What determines the price of household reverse osmosis?
From the above information it can be seen that there are various options for reverse osmosis systems ,household Ro plant, industrial Ro plants etc. which differ in configuration, the presence of various options, and so on, which certainly affects their price. However, on the market you can often find products of different brands, which, with the same type of equipment, have significant differences in price. Most consumers have a logical question – what is the reason for the difference in price and is it worth paying?
As an example, we can consider the membrane element as the basis of the entire system. Inexpensive reverse osmosis systems are usually equipped with membrane elements from little-known manufacturers. For such membrane elements, the problems discussed above with the chlorination of the fabric, patches, and poor-quality adhesive joints are typical. All this does not add reliability to the system. In addition, such elements may have lower performance and selectivity compared to products from leading manufacturers. On the contrary, in more expensive reverse osmosis systems, it is most likely that Dow Filmtec membrane elements are found that have the best performance in terms of performance to selectivity and provide better cleaning quality. A similar situation is observed for pre filter cartridges. In low-cost systems, it is most likely to encounter Chinese-made cartridges, which often show a high filtration rate with an unsatisfactory quality of water purification from impurities. Therefore, with such cartridges the membrane service life is significantly reduced, the quality of cleaning as a whole is deteriorated. In this case, a situation arises when the attractively low initial cost of the system leads to more frequent replacements of cartridges and, consequently, to large maintenance costs. And vice versa – more expensive solutions, equipped with high-quality cartridges and membranes, require less frequent maintenance and are cheaper. We should not forget about the post-treatment, especially about the re mineralization of water. The effectiveness of this process is determined by the nature of the minerals used and the time of contact with water. Since water re mineralization is carried out at the final stage of the purification process, the purity of the minerals used and the absence of toxic impurities in them are extremely important. In general, post-treatment of water is the most critical stage in household reverse osmosis, as it determines the safety of the water supplied to the consumer. This should be borne in mind when choosing the manufacturer of the system you are buying. A separate point in the distinction between cheap and expensive solutions is the question of the quality of systems. As a rule, not only the high efficiency of their work, but also the high reliability of the reverse osmosis system is behind the higher price of components. A thorough check by the manufacturer of his products for work under pressure, resistance to water hammer and other difficult tests that the product passes in the quality control department is a guarantee of the absence of problems with flooding of neighbors, loss of water and other troubles. And you also have to pay for it.
For further information click here : Ro plant price in Pakistan
watertreatment 