
Complex dosage:
To ensure that the chemical coagulation water treatment process runs optimally, the correct dosages of the additives should be considered. The speed and efficiency of the process can vary depending on the pH of the solution. Therefore, acids or bases must be added to ensure that the pH is at a neutral level. After this step, the coagulant must be introduced in the optimum dosage. This specific dosage is required to ensure that the effluent is completely destabilized. If too many chemicals are added, the solution will stabilize again with the opposite charge of the original mixture. Coagulants can also be added to increase the density and toughness of the aggregates. This extra chemical can cause the particle to precipitate faster and stay together during mixing and settling. Therefore, there are three different additives that must be tested and optimized for a particular particle makeup of the effluent. So an efficient water filter for home is required to fix that problem .
High variance of water composition:
After all the work, figure out how many of which chemicals need to be added to the effluent to treat it. The chemical dosage may not even work correctly. Because, if the effluent has a varying turbidity or particle composition, the results must be adjusted accordingly. Even if waste water comes from the same source, its composition is not always consistent. As mentioned earlier, accuracy is very important when dosing the effluent with the help of chemicals. Therefore, if a treatment system were pulled from one water source and the dosage was optimized to treat this source. The optimized dosage can be highly variable to treat another similar water or waste water source.
Difficult to process multiple contaminants at the same time:
Waste water waste often contains many contaminants. These contaminants can vary from organic compounds to heavy metals to oils, fats and hardness. Certain chemical additives are effective in coagulating certain components in the raw water. However, there would be different chemical additives to treat different components. In short, one pass is often not sufficient to process all unwanted particles using a chemical coagulation system. In this case, another chemical coagulation step may need to be used. Perhaps another removal method should be used altogether.
High operating costs:
The six disadvantages mentioned above all contribute to this last disadvantage – operational costs. The volume of the sludge produced makes it more expensive to transport. The dangerous nature of the sludge makes it more expensive to throw it away. The required quantities of chemicals, even if the chemicals themselves are not expensive, can entail considerable costs. A chemical coagulation water treatment system requires complex dosages. Variations in the composition of the spring water may require extensive testing. This contributes to additional operational costs.
Finally, not all unwanted particles and possible microbiological contamination can be removed in one chemical treatment process. An additional step must therefore be added. This is especially applicable to water sources, including microbiological contamination, because chemical coagulation does not affect these problems. These extra steps contribute to the operating costs. None of the above reasons even includes the additional costs of cleaning and maintenance when using a chemical coagulation system. Other additional costs include the labor required for training, testing, operation, monitoring, or cleaning and maintenance.
For further information click here : Ro plant price in Pakistan